The user mode command show version gives us information about the general configuration of the router. Tthe output generated by the show version command on our test 2520 router testrouter.

    1. testrouter>show version
    2. Cisco Internetwork Operating System Software
    3. IOS (tm) 2500 Software (C2500-JS-L), Version 11.3(5), RELEASE SOFTWARE (fc1)
    4. Copyright (c) 1986-1998 by cisco Systems, Inc.
    5. Compiled Tue 11-Aug-98 04:06 by phanguye
    6. Image text-base: 0x030489A8, data-base: 0x00001000
    7. ROM: System Bootstrap, Version 11.0(10c), SOFTWARE
    8. BOOTFLASH: 3000 Bootstrap Software (IGS-BOOT-R), Version 11.0(10c), RELEASE SOFTWARE (fc1)
    9. Dallas uptime is 4 hours, 18 minutes
    10. System restarted by reload
    11. System image file is "flash:c2500-js-l.113-5", booted via flash
    12. cisco 2520 (68030) processor (revision M) with 6144K/2048K bytes of memory.
    13. Processor board ID 10353405, with hardware revision 00000003
    14. Bridging software.
    15. X.25 software, Version 3.0.0.
    16. SuperLAT software copyright 1990 by Meridian Technology Corp).
    17. TN3270 Emulation software.
    18. Basic Rate ISDN software, Version 1.0.
    19. 1 Ethernet/IEEE 802.3 interface(s)
    20. 2 Serial network interface(s)
    21. 2 Low-speed serial(sync/async) network interface(s)
    22. 1 ISDN Basic Rate interface(s)
    23. 32K bytes of non-volatile configuration memory.
    24. 16384K bytes of processor board System flash (Read ONLY)
    25. Configuration register is 0x2102
    26. testrouter>

Post By Editor (2,827 Posts)

Website: →

Connect